IRForum

Hi again.

Sorry I write over an old thread, but here is just the info I need to follow.

My question:

Do you thing it is possible to use 8 IR LED from an ESP8266? (Vishay TSAL6400)
I want to be able to "shoot" IR signals in all directions at the same time. (up, left, right, front... 2 IR in each side)

Actually I use this circuit https://www.analysir.com/blog/2016/07/0 ... sing-uart/ without R1, R2, Q1 with 2 IR LEDs

Thanks for the help.

Regards

Javier.

Hi Javier

Unless you have a very very big room, I would think that running 2 IR LEds with 300mA current running thru them should suffice for most domestic setups.

You could also use a mix of angles in the IR LED e..g. TSAL6100, TSAL6200, TSAL6400

see the photo in the updated ESP8266/NodeMCU post on our blog
https://www.analysir.com/blog/2017/01/2 ... r-signals/

By using the 5V power rail, you should be able to wire up 2 IR LEDs in series in most circuits.....Just like the Photo of our SendIR module in the photo of the article above.

FYI: SendIR is available via our shop & we also plan to release an IR shield for the Wemos Esp8266/NodeMCU modules in the next month or 2.
https://www.analysir.com/blog/shop/

But to answer your question, you could run 8 LEDs, as long as you take the current from the 5V rails and dont exceed its capacity/rating (typically 500mA total??). However, this would be extreme overkill for 99% of applications.