Page 2 of 2

Re: Bose Sounddock II

Posted: Tue Nov 15, 2016 12:21 am
by AnalysIR
Yes, they look a lot better now & should be OK to send.

I will try to get some time tomorrow to add this new protocol to AnalysIR for you & you should then be able to 'clean/correct' the timings for better performance.

PS: I will also delete the file above with the bad signals.

Re: Bose Sounddock II

Posted: Tue Nov 15, 2016 2:07 pm
by AnalysIR
OK -I have added BOSE to AnalysIR and will send you the config file update by email shortly.

You can then use the Clean function to correct the signal timings vis the Power Tools menu. (Gives better performance and range)

Let me know how you get on.

Re: Bose Sounddock II

Posted: Tue Nov 15, 2016 2:18 pm
by marcolino7
Hi,
thanks for all your help. Let me have config file and then I'll try to clean/correct, I have no idea on how perform, but I'll check documentation.

I have a quick off topic quetion. If I open File->View Properties, I can find between protocol Daikin, but in Protocols MenĂ¹ there is not Daikin Available. I notice that, because my AIRCo in my lab is a Daikin clone. With old version o AnalysIR the remote of this Airco unit is detected as Daikin, now is detected as RAW.

Marco

Re: Bose Sounddock II

Posted: Tue Nov 15, 2016 2:28 pm
by AnalysIR
Open a new topic and post the saved session file & I will have a look.

PS: I noticed on your Bose signals that yout IR receiver is struggling a bit.
try o increase the tolerance sliderto 140% to see if that helps.

Re: Bose Sounddock II

Posted: Tue Nov 15, 2016 2:46 pm
by marcolino7
Hi,
I'll follow your suggestion and I perform a new capture from my Daikin Clone remote, and I'll send Session in new topic.

Thanks

Marco