IRForum

Code: Select all

 mySender.send(rawData, RAW_DATA_LEN, 2) 

Code: Select all

 mySender.send(SONY,0xa8bca, 20); 

Code: Select all

  IrSender.sendNEC(0x0102, 0x34, true, 0); 

Code: Select all

 mySender.send(xyz); 

Code: Select all

#include <IRLibSendBase.h>    //We need the base code
#include <IRLib_HashRaw.h>    //Only use raw sender

IRsendRaw mySender;
#define RAW_DATA_LEN 2
uint16_t rawData[RAW_DATA_LEN] = { 2406,  1000};

int button = 4;

void setup() {
  Serial.begin(9600);
  delay(2000); while (!Serial); //delay for Leonardo
  pinMode(button, INPUT);
  Serial.println(F("Every time you press a key is a serial monitor we will send."));
}

void loop() {

  if (digitalRead(button) == HIGH) {
    for (int i = 0; i < 3; i++)
    {
      mySender.send(rawData, RAW_DATA_LEN, 2); //Pass the buffer,length, optionally frequency
      Serial.println(F("Sent signal."));
    }
  }
}

Code: Select all

#include <IRLibRecvPCI.h> 

IRrecvPCI myReceiver(2);//pin number for the receiver

void setup() {
  Serial.begin(115200);
  delay(2000); while (!Serial); //delay for Leonardo
  myReceiver.enableIRIn(); // Start the receiver
  Serial.println(F("Ready to receive IR signals"));
}

void loop() {
  //Continue looping until you get a complete signal received
  if (myReceiver.getResults()) { 

    for(bufIndex_t i=1;i<recvGlobal.recvLength;i++) {
      Serial.print(recvGlobal.recvBuffer[i],DEC);
      Serial.print(F(", "));
      if( (i % 8)==0) Serial.print(F("\n\t"));
    }
    Serial.println(F("1000};"));//Add arbitrary trailing space
    myReceiver.enableIRIn();      //Restart receiver
  }
}