IRForum

I bought AnalysIR last week to attempt decoding of my air conditioner remotes to eventually automate them, but am still waiting for my Arduino to arrive. I tried using AnalysIR with a Moteino that I have already. However all I see when I start the sketch is:

!AnalysIR!
!Free RAM: 131!

Is this a warning saying that I won't have enough RAM to get my data? I am pretty sure I have the correct pins as my system works fine with this library:

http://www.righto.com/2009/08/multi-pro ... brary.html

producing an output like this:

4650 -2400 400 -350 400 -900 400 -900 400 -300 450 -850 450 -300 400 -300 450 -300 400 -300 450 -900 400 -300 400 -350 400 -900 400 -300 400 -350 400 -300 450 -850 450 -850 450 -300 400 -300 450 -300 400 -350 400 -850 450 -300 400 -350 400 -300 400 -350 400 -300 450 -300 400 -900 400 -300 450 -300 400 -350 400 -300 400 -350 400 -300 400 -900 400 -350 400 -300 450 -300 400 -900 400 -900 400 -900 400 -300 450 -850 450 -300 400 -350 400 -300 400 -350

Using same hardware setup I don't see anything on AnalysIR though. I'd just like to check whether possibly the moteino isn't up to the job of working with AnalysIR.

Thanks,

Dave

The SRAM shouldn't be an issue, as we reserve most of it for storing the signals.

I will check out the motion specs shortly to see if it is OK.

Thanks for the clarification & sorry for double post - wasn't sure the first one made it through.

The moteino has an RF board connected to it which uses D2
(http://lowpowerlab.com/moteino/#pinout)
so I have been messing around with other pins - tried 3 & 5 so far but no luck getting any further. Pin 5 works with the other library but still researching PWM & interrupts, etc. I did change the line in the code to:
#define IR_Rx_PIN 5 //IR digital input pin definition - drives interrupt ' was originally 2 but 5 works with other software

Anyway, not a major problem - the real Arduino should arrive from China this week so will get it working with that first then migrate to the Moteino once I understand more what I am doing. Will then let this board know what changes are needed.

Thanks,

Dave

I will email you a sketch directly that should work OK for Moteino, but without the option of carrier frequency.

In this case the IR receiver, will be connected to pin D3 (instead of D2)