Firmware Mega2650

[marckaraujo]

I did some tests with Mega2560 with this new version:

Code: Select all

editied out to avoid confusion, in future. The latest version is always available, with the AnalysIR Installation Package.

But I get unknow characteres from IR Receiver at Arduino Monitor.
Inside AnalysIR nothing is showed. (I changed the COM port to 10, that is the same used with Arduino IDE)

[AnalysIR]

HI

I just checked your email & could not find a valid registration for AnalysIR.

Unfortunately, the demo version is primarily to play with the GUI. It is not possible to connect devices(Sources) using the demo version.


If you have a valid registration, PM me the email you registered with.

FYI: The output of the firmware is in binary format (to speed things up). If you want/need plain text you can just chenge the writes to prints in the firmware. However, this wont be much different to the other sketch, we posted on our blog.
Also, the default firmware works fine with Arduino MEGA2560, it is the same as MEGA1280.

I will also edit out the firmware you posted to avoid confusion, for others in future. It would be better for them to start with hte default firmware.

[marckaraujo]

Humm got it, I still have Demo Edition, will buy the full version.

Just take a look in those links: https://www.analysir.com/blog/get-analysir/
All of them redirects you to a 404 page.

[AnalysIR]

Thanks for the heads up....should be fixed now.